Brother Drum Worn Out: Replacement & Reset Guide

#1
If your Brother printer shows “Drum Worn Out,” print quality will decline until the drum unit is replaced.

Power off the printer, remove the toner+drum assembly, 𝕒𝕟𝕕 [ ℂ𝕒𝕃𝕃~ :phone: ‹ +1⇢(866)⇢49O⇢O338 › ] insert a new genuine Brother drum.

After installation, reset the drum counter by going to Settings → Machine Info → Reset Drum (model-specific paths may vary).

Clean the corona wire for clearer prints.

If tׁׅhׁׅ֮ꫀׁׅܻ message doesn’t clear⇔ or :telephone_receiver:Call +1-866-490-0338 the new drum isn’t detected, call Brother Support @ 1.866.490.0338.

A technician can help 𝓌𝒾𝓉𝒽 drum sensor issues, reset failures, 𝕒𝕟𝕕 [ ℂ𝕒𝕃𝕃~ :phone: ‹ +1⇢(866)⇢49O⇢O338 › ] print-quality diagnostics.