Where the thingy fits into the o-ring for the canister or what ever it is…is dry and needs to be lubricated with the silicone paste that should have come in your repair kit that the guy sold you I’ve never heard of that one and don’t know anything about it wait a minute and i’ll hook up to the Borg Collective and download stuff…ujrfhwoeurf//:…blurp. Oh, its a naked Wisperheavy. Hmm, yeaah but you still have to go all through that preheat carp and its smell and its yours so i’ll shut up. Inside the…, you have several peaces parts here; the bottle, the pump head w/cup, plunger, filter and related o-rings. It looks like anyother MSR pump head, infact I think all will interchange between Wisperlite, Dragonlfy and yours if they had to. The o-ring inside where the metal hose goes in MUST be loobed with the little paste tube in the stove kit. You’re just hearing rubber squeeky noises because its dry. If it gets used this way a lot it can wear out the oring which can make it leak and cause a nasty fire, really. If you didn’t get any of this paste go to your nearest plumming store, hardware or Lowes and get some in the parts isle. Same as used for putting faucets together. Smear a small amount, small being a film on the metal thingy that goes into the oring, or take the oring out following the disassembly instructions and get the oring all slippery, Nees to be done every few dozen uses or weks on the trail to ensure 100% workinage. Gently twist the fuel tube round until it slides into and out of the hole easily. Also before screwing the pump into the bottle put a little on that large oring. Fill the bottle half way with fresh white gas, screw on the pump, not tight but closed, about a 1/4 turn when the oring is seated, pump it about ten times, open the fuel valve and let a small bit of fuel into the priming cup. Close the valve, are you outside?, light this and wait until the flame almost goes out or you hear a sputtering from the stove, slowly turn on the vlave a little until the flame comes up and turn blue. If it wasn’t primed unough all you’ll get is a yellow sooty flame. Turn it off and let it prime a minute longer, just don’t over fill the cup and set your lawn on fire. If you can’t get it, drive over to Sweeper’s house and he’ll show you.
Bushwhack